iPhone 6S Update System failed with an error of 4013, and the detection found that Inductor pin dropped an pin on the reverse side, which was normal after replacement.
iPhone 6s mobile phone inlet is unable to turn on, and the component is directly replaced by the backlight.
iPhone 6s mobile phone touchs the failure, the touch related to the touch is excluded, the screen is also replaced, and finally the R3144 should be empty. The pad is shorted, and the fault repair is fixed after disconnection.
The iPhone 6s black screen does not respond, and the test is found to be caused by backlight booster inductance, and after replacement, the problem is repaired.
iPhone 6s mobile phone doesn't display, and no display was repaired several times. It was found that the backlight chip was burnt, and Jump wire made some repairs.
The rear Camera of iPhone 6s does not work. After testing, the motherboard 2.85V camera MOSFET and the fourth pin have corrode dropped, just one line to get it.
iPhone 6s no display, backlight chip DWI bus disconnection leads to no backlight maintenance ideas!
iPhone 6s card changing slot, Nand was blown by Inveracious Soldering, which directly led to Won't Turn On, Reballing Nand being installed, starting up and entering the system normally, and the maintenance was finished.
IPhone6s didn't respond when it was turned on, and Update System reported an error of 4013. The detection found that it was Inductor pin bit, and the reverse side dropped an pin. Repair after replacement.