There is a resistor corrosion on the motherboard, so directly remove the corrosion resistor and make a short circuit. After power-on test, the mobile phone WiFi can be turned on normally and the fault can be repaired.
Check the small board and find that there is corrosion next to the microphone. Remove the chip, clean the pad and redo the filter next to it. Boot test, perfect repair.
Machine model: Glory X30i
Glory X10 mobile phone can't be charged. It can be charged when it's turned off. If you plug it in after you turn it on, it won't charge. If you know the secret, the solution is so simple.
The Previously repaired machine cannot be turned on. Remove the main power supply and find that the bottom pin Short bridge, and a point is dropped,Boardview sees the point leading to CLK, circle this point Jump wire,Solder Mask UV curable.
Glory 20 mobile phone can't boot, usually this is basically the upper cover, but because it is two repairs, first put the CPU to keep it, and then the machine is lit.
After Fall hard, WiFi cannot be turned on. Carefully observe the motherboard and refer to Xinzhizao Soft drawing. It is found that CLK is disconnected, and Jump wire is repaired.
